battery replacement RENAULT SCENIC 2009 J84 / 2.G Engine And Peripherals EDC16 Workshop Manual

DIESEL INJECTION
Fault finding – Replacement of components13B
13B-20V3 MR-372-J84-13B250$225.mif
EDC16
PROGRAM No: C1
Vdiag No.: 51DIESEL INJECTION
Fault finding – Replacement of components
COMPUTER REPLACEMENT OR REPROGRAMMING
Operations to be carried out before reprogramming the injection computer:
Before reprogramming the injection computer, move the main CC/SL switch to the rest position. The information
about the cruise control or the speed limiter displayed on the instrument panel disappears.
Otherwise, if the main switch remains in the cruise control or speed limiter position during and after reprogramming,
the Cruise control/Speed limiter function will not be operational.
The procedure for resetting the function is as follows:
–Vehicle ignition on.
–Move the cruise control/speed limiter switch to the rest position (the computer detects the rest position at that
moment).
–Move the cruise control/speed limiter switch to the Cruise control position to activate the Cruise control function.
–Move the cruise control/speed limiter switch to the Speed limiter position to activate the Speed limiter function.
Two operations must be performed when replacing or reprogramming the computer:
SC003 Save computer data and SC001 Enter saved data.
–Use SC003 before the computer is replaced or reprogrammed. This enables certain data to be saved in the
diagnostic tool so that the new computer* can be reconfigured like the old one. The saved data are: injector
codes, EGR programming, vehicle options.
–Run SC001 after the computer is replaced or reprogrammed. It enables you to rewrite the data (saved by
command SC003) to the new computer*.
If you cannot establish dialogue with the computer being replaced: you will not be able to save anything. After
replacing the computer, enter the IMA code of each injector manually, reading the code on each injector (see
INJECTOR REPLACEMENT).
Exhaust gas recirculation valve data is programmed automatically the 1
st time the new computer is switched on*.
* new computer or reprogrammed computer. IMPORTANT
–Switch on the diagnostic tool (mains or cigarette lighter supply).
–Connect a battery charger.
–Switch off all electrical consumers (lights, interior lights, air conditioning, radio/CD, etc.).
–Wait for the engine to cool (engine coolant temperature < 60˚ and air temperature < 50˚).
–The GMV are activated automatically when the computer is being reprogrammed.